Digilent Pcam 5C 410-358 참조 매뉴얼 - 페이지 8

{카테고리_이름} Digilent Pcam 5C 410-358에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilent Pcam 5C 410-358 8 페이지. Imaging module

The signals are briefly described in the table below.

Header J3

Pin Signal

Description

1 GPIO0

Camera GPIO 0

2 GPIO1

Camera GPIO 1

3 FREX

Frame exposure mode shutter signal 7 VCMGND Auto-focus voice coil motor ground

4 STROBE Flash LED strobe signal

Liquid Lens Support

The Pcam 5C PCB was designed to allow for the incorporation of circuitry that can drive an auto-

focus M12 liquid lens assembly, such as those created by Varioptic. The circuitry needed to drive a

liquid lens assembly is not loaded in the current version of the Pcam 5C (see page 2 of the Pcam 5C

Schematic), however this functionality may be incorporated into a future version of the Pcam 5C. If

you are interested in obtaining a liquid lens capable version of the Pcam 5C, please contact Digilent

using the Digilent Forum.

Additional Information

The schematics of the Pcam 5C are available here. Additional information about the OV5640 image

sensor SoC can be found in the sensor datasheet, which can be obtained by contacting OmniVision.

A brief overview of the OV5640 is publicly available in the OV5640 Product Brief.

Example code demonstrating how to use the Pcam 5C can be found on its Resource Center.

If you have any questions or comments about the Pcam 5C, feel free to post them under the

appropriate section ("Add-on Boards") of the Digilent Forum.

pcam, pcam-5c, add-ons, reference-manual, doc

https://reference.digilentinc.com/reference/add-ons/pcam-5c/reference-manual 1-9-18

Pin Signal

Description

5 GND

Power Supply Ground

6 VCMSINK Auto-focus voice coil motor sink