Cres Cor AquaTemp CO-151-FWUA-12DX2081BC 설치, 운영 및 유지보수 매뉴얼 - 페이지 10
{카테고리_이름} Cres Cor AquaTemp CO-151-FWUA-12DX2081BC에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor AquaTemp CO-151-FWUA-12DX2081BC 17 페이지. Humidity convection ovens
페이지 인쇄5925 Heisley Road • Mentor, OH 44060-1833
OPERATING INSTRUCTIONS (continued)
HOW TO USE THE AQUATEMP HUMIDTY CONTROL:
* The units of the humidity control are approximate % relative humidity .
The amount of moisture will vary for the same %RH value at different
oven temperatures .
* The LOW WATER Light comes on when water pan needs to be refilled.
* Press the ON/OFF button to turn it on .
Setting the Humidity:
1 . At any time, press the knob and the setpoint %RH will flash.
2 . Turn the knob to the value you desire .
3 . Press the knob to set the value .
NOTE: These humidity values then are set and switch automatically based
The DISPLAY BUTTON momentarily shows the approximate relative
humidity in the oven . When water level is low, %RH is not correct, so no
value is displayed and the water heater does not heat .
NOTES:
It is recommended to use treated water to prevent failure of fill valve.
LOW WATER LIGHT:
MANUAL FILL: When water needs to be added to the pan, the Low Water
Light will stay on and the humidity will not work until the pan is refilled.
AUTO FILL: If water level is low and water supply is not connected, an
error code will display after a time limit .
(See MENU SETTINGS to turn auto fill on and off)
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
upon which Roast-N-Hold mode it is in .
Convection
FL-2373-BC
Humidity Oven
Page 10 of 17
Rev. 1 (8/20)