Cres Cor AquaTemp CO-151-FWUA-12DX2081BC 설치, 운영 및 유지보수 매뉴얼 - 페이지 12

{카테고리_이름} Cres Cor AquaTemp CO-151-FWUA-12DX2081BC에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor AquaTemp CO-151-FWUA-12DX2081BC 17 페이지. Humidity convection ovens

페이지 인쇄

5925 Heisley Road • Mentor, OH 44060-1833

Drain water pan and clean interior of unit as per instructions in FL-2373-BC

Check hinges and latch and adjust as needed per instructions in FL-2373-BC

Check that meat probe does not have any fraying wires or exposed conductors .

Check that cooling fans are operating when unit is running at cooking temps .

They are controlled by a thermal switch and may not kick on until unit has been

IF OVEN GETS TOO HOT OR WON'T SHUT OFF, DISCONNECT

POWER AT BRANCH PANEL. DO NOT UNPLUG CORD!

1 . Cord is unplugged from wall outlet .

2 . Circuit breaker/fuse to wall outlet is blown .

NOTE: Vent fans will not operate until the control compartment requires ventilation to limit temperatures . Replacement

of electrical components must be done by a qualified electrician.

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

MAINTENANCE INSTRUCTIONS

HOW TO ADJUST THE DOOR LATCH:

1 . For vertical (up and down movement) adjustment:

a . Loosen (2) screws located in magnetic strike .

b . Move strike up or down for alignment to magnet on latch .

c . Tighten screws to secure

2 . For horizontal (greater or lesser magnetic draw) adjustment:

a . Loosen (4) screws in door latch .

b . Move latch forward or backward to adjust magnetism .

c . Tighten screws to secure .

Replace as needed .

operating for some time .

If unit is NOT working, first check the following causes:

Daily

Weekly

Monthly

WARNING

3. Switch is turned off.

4 . Fuse on back of unit is blown .

Convection

FL-2373-BC

Humidity Oven

Page 12 of 17

Rev. 1 (8/20)