Cres Cor Tri-Powered Series 운영 및 유지보수 지침 매뉴얼 - 페이지 4

{카테고리_이름} Cres Cor Tri-Powered Series에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cres Cor Tri-Powered Series 12 페이지. Hot cabinets

Holding Cabinet

Rev. 4 (10/13)

Page 4 of 12

HC-UA-11 FOR PROPANE CYLINDER INSTALLATION:

WARNING

1 . Only use a 1 lb . standard cylinder marked "PROPANE" . A larger tank can be used with an adapter (optional

accessory part number 0904-026-K See installation FL-2362) .

2 . The cylinder must be constructed and marked in accordance with the specifications for propane cylinders of the

U .S . Department of Transportation (DOT) or CAN/CSA B339 .

3 . The Cylinder should not be allowed to remain in a high heat area, such as a car, truck or direct sunlight . DO NOT

store at temperatures above 120°F (49° C) and in unauthorized storage areas not intended for cylinder storage.

4 . Hold and use the cylinder in an upright position and only use when temperatures are above 10°F (-12° C). Do not

attach near flames, pilot lights or sparks.

5 . Propane Tank Hook-up:

a . Make sure the cabinet switch is in the "OFF" position .

b . Uncap the cylinder, hold upright and insert it in the right rear compartment of the cabinet . Hand screw and

tighten the cylinder to the gas regulator . DO NOT over-tighten.

Check for leaks at the connection: Spray soapy water onto the connection and look for bubbles . Tighten more if

needed .

6 . Disconnect the cylinder when not in use . Replace the cylinder cap when storing .

HC-UA-11-NG FOR NATURAL GAS INSTALLATION ONLY:

1 . Installation shall be made with a connector that complies with Standards for Natural Gas Connection on

Movable Appliances ANSI/Z21.69b/CSA 6.166-2006.

CAUTION

2 . The cabinet and its individual shutoff valve must be disconnected from the gas supply piping system during

any pressure testing of the system at pressures exceeding 1/12 psig (3 .45 kPA) . During pressure testing

of the gas supply piping system at pressures equal to or less than 1/2 psig (3 .45 kPA), the cabinet must be

isolated by closing the manual shutoff valve.

3 . Check for leaks at the connection: Spray soapy water onto the connection and look for bubbles . Tighten more if

needed .

FL-2361

INSTALLATION INSTRUCTIONS

This cabinet is not intended for use with natural gas.

It is not user-convertible to natural gas.

Adequate means to limit the movement of the cabinet without

depending on the connector, quick connect or associated piping

must be provided by the installer.

5925 Heisley Road • Mentor, OH 44060-1833