Digilock Numeris Versa 제품 설명서 - 페이지 4
{카테고리_이름} Digilock Numeris Versa에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilock Numeris Versa 10 페이지. Keypad
페이지 인쇄
Programming Instructions
Replace Keys
The locks must be reprogrammed to prevent the lost/stolen keys from operating a lock.
1
To replace the Programming Key:
Note the order or serial number (found on the lock's rear unit).
1a
To replace the Manager Keys:
Collect all remaining and replacement Manager Keys.
Go to any lock operated by the lost/stolen Manager Keys.
Press
=` 55 `
.
The LED will turn on.
Set Lock Functionality
Each lock can be set for either shared or assigned use functionality. Press = to check functionality. If in shared use, LED is red. If in
assigned use, LED is green.
1
To set for assigned use:
Press
.
=` 65 `
The red LED will turn on.
4
Product Guide
1b
2
Insert the Programming Key.
A two-tone beep will be heard
and the green LED will fl ash once.
Keypad
Shared & Assigned Use Functionality
2
Contact Digilock Support to purchase a replacement Programming Key.
2a
Insert the Programming Key.
A two-tone beep will be heard.
Insert the Programming Key again.
Three sets of two-tone beeps will be heard and the LED will turn off. All
previously programmed Manager Keys will be erased.
Follow instructions to Add Manager Keys to program the remaining and
replacement Manager Keys to the locks.
1
To set for shared use:
Press
.
=` 56 `
The green LED will turn on.
2b
2
Insert the Programming Key.
A two-tone beep will be heard
and the red LED will fl ash once.