Digilock numeris aspire 제품 설명서 - 페이지 4

{카테고리_이름} Digilock numeris aspire에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilock numeris aspire 11 페이지. Touch rfid latch mechanism
Digilock numeris aspire에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지), 제품 설명서 (6 페이지)

페이지 인쇄
Digilock numeris aspire 제품 설명서
Programming Instructions
Set Lock Functionality
Each lock can be set for either shared or assigned use functionality. Press
use, LED is green.
1
To set for assigned use:
Press
= ` 6 5 `
The red LED will turn on.
Assign User Credentials (for assigned use functionality only)
Make sure that the lock is set for assigned use functionality (a green LED will flash when
and/or User Keys) may be assigned to each lock.
1a
Assign User Codes:
Press
= ` 5 5 `
The LED will turn on.
Insert a valid Manager Key.
A two-tone beep will be heard.
1a
Assign User Keys:
Press
= ` 5 5 `
The LED will turn on.
Insert a valid Manager Key.
A two-tone beep will be heard.
4
2
Insert the Programming Key.
.
A two-tone beep will be heard
and the green LED will flash
once.
1b
.
1b
.
Product Guide
Standard Keypad
Bolt Mechanism
to check functionality. If in shared use, LED is red. If in assigned
=
1
To set for shared use:
Press
= ` 5 6 `
The green LED will turn on.
is pressed). Up to 20 user credentials (User Codes
=
2a
[a new 4-7 digit code]
Press
=
[the same 4-7 digit code]
Press
=
Two sets of two-tone beeps will be heard and the LED will turn off.
2
Insert a User Key.
Two sets of two-tone beeps will be heard and the LED will turn off.
Shared & Assigned Use Functionality
2
Insert the Programming Key.
.
A two-tone beep will be heard
and the red LED will flash
once.
2b
. A two-tone beep will be heard.
`
.
`