Digilock numeris aspire 제품 설명서 - 페이지 2

{카테고리_이름} Digilock numeris aspire에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilock numeris aspire 6 페이지. Touch rfid latch mechanism
Digilock numeris aspire에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지), 제품 설명서 (11 페이지)

페이지 인쇄
Digilock numeris aspire 제품 설명서
Setup
Locks are shipped with factory default settings (only operates by pressing
and manager credentials (Manager Key or RFID).
1
Insert the Programming Key.
A two-tone beep will be heard
and the LED and Reader will
turn on.

Programming Instructions

Express Register Manager Credentials
The Programming Key can quickly program the locks to operate with the same manager credentials.
1
Go to the lock already programmed to operate with the manager
credentials.
Touch and hold
for 10 seconds (a two-tone beep will be heard
`
after 5 seconds followed by 2 sets of two-tone beeps after 10
seconds) then release. The LED will flash.
3
Insert the Programming Key to program each lock to operate with
the same manager credentials.
Two sets of two-tone beeps will be heard and the LED will flash
once to indicate successful programming.
*The Programming Key will continue to function in express registration mode until it is used to operate a lock.
2
Product Guide
2
Insert one Manager Key or
present one Manager RFID at
a time.
A two-tone beep will be heard
for each manager credential
programmed.
Touch RFID
Latch Mechanism
). Each lock must be setup to operate with a Programming Key
`
3
Insert the Programming Key.
A two-tone beep will be heard
and the LED and Reader will
turn off.
2
Insert the Programming Key.
Two sets of two-tone beeps will be heard and the LED will turn off.
4a
End express registration mode.*
Go to any programmed lock.
Touch
then insert the Programming Key.
`
Assigned Use Functionality
4
Repeat above steps for each
lock or follow instructions to
Express Register Manager
Credentials to setup all the
locks.
4b