Digilock numeris aspire Ürün Kılavuzu - Sayfa 2

Tuş takımı Digilock numeris aspire için çevrimiçi göz atın veya pdf Ürün Kılavuzu indirin. Digilock numeris aspire 6 sayfaları. Touch rfid latch mechanism
Ayrıca Digilock numeris aspire için: Kurulum Kılavuzu (16 sayfalar), Ürün Kılavuzu (11 sayfalar)

Sayfayı Yazdır
Digilock numeris aspire Ürün Kılavuzu
Setup
Locks are shipped with factory default settings (only operates by pressing
and manager credentials (Manager Key or RFID).
1
Insert the Programming Key.
A two-tone beep will be heard
and the LED and Reader will
turn on.

Programming Instructions

Express Register Manager Credentials
The Programming Key can quickly program the locks to operate with the same manager credentials.
1
Go to the lock already programmed to operate with the manager
credentials.
Touch and hold
for 10 seconds (a two-tone beep will be heard
`
after 5 seconds followed by 2 sets of two-tone beeps after 10
seconds) then release. The LED will flash.
3
Insert the Programming Key to program each lock to operate with
the same manager credentials.
Two sets of two-tone beeps will be heard and the LED will flash
once to indicate successful programming.
*The Programming Key will continue to function in express registration mode until it is used to operate a lock.
2
Product Guide
2
Insert one Manager Key or
present one Manager RFID at
a time.
A two-tone beep will be heard
for each manager credential
programmed.
Touch RFID
Latch Mechanism
). Each lock must be setup to operate with a Programming Key
`
3
Insert the Programming Key.
A two-tone beep will be heard
and the LED and Reader will
turn off.
2
Insert the Programming Key.
Two sets of two-tone beeps will be heard and the LED will turn off.
4a
End express registration mode.*
Go to any programmed lock.
Touch
then insert the Programming Key.
`
Assigned Use Functionality
4
Repeat above steps for each
lock or follow instructions to
Express Register Manager
Credentials to setup all the
locks.
4b