Cisco 200E Series 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} Cisco 200E Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 200E Series 13 페이지. Advanced smart switches

Possible Causes and Resolutions

No Power:

Power up the switch and your computer if they are turned off.

Bad Ethernet connection:

Check the LEDs for proper indications. Check the connectors of the

Ethernet cable to ensure they are firmly plugged into the switch and

your computer.

Bad Console port connection:

Check the console cable connectors to make sure they are firmly

plugged into the switch and your computer. Make sure the console

port utility is configured with the correct parameters.

Wrong IP address:

Make sure you are using the correct IP address of the switch. You can

determine the current IP address of the switch from the CLI through the

console port interface, or from your network administrator. The System

LED provides an indication of where the switch received the IP

address. (See Section 4 for details.)

Make sure that no other device is using the same IP address as the

switch.

No IP route:

If the switch and your computer are in different IP subnets, you need

one or more routers to route the packets between the two subnets.

Unusually long access time:

Due to the standard spanning tree loop detection logic, adding new

connections may take 30 to 60 seconds for the affected interfaces

and/or LAN to become operational.

Features of the Cisco Small Business

Smart Switch

This section describes the exterior of the advanced smart switches

including ports, LEDs, and connections.

Front Panel Ports

The ports and LEDs are located on the front panel of the switch.

RJ-45 Ethernet Ports—Use these ports to connect network devices, such

as computers, printers, and access points, to the switch.

200E Series Advanced Smart Switches