Cisco 200E Series Schnellstart-Handbuch - Seite 8
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Schalter Cisco 200E Series herunter. Cisco 200E Series 13 Seiten. Advanced smart switches
Seite druckenPossible Causes and Resolutions
No Power:
Power up the switch and your computer if they are turned off.
Bad Ethernet connection:
Check the LEDs for proper indications. Check the connectors of the
Ethernet cable to ensure they are firmly plugged into the switch and
your computer.
Bad Console port connection:
Check the console cable connectors to make sure they are firmly
plugged into the switch and your computer. Make sure the console
port utility is configured with the correct parameters.
Wrong IP address:
Make sure you are using the correct IP address of the switch. You can
determine the current IP address of the switch from the CLI through the
console port interface, or from your network administrator. The System
LED provides an indication of where the switch received the IP
address. (See Section 4 for details.)
Make sure that no other device is using the same IP address as the
switch.
No IP route:
If the switch and your computer are in different IP subnets, you need
one or more routers to route the packets between the two subnets.
Unusually long access time:
Due to the standard spanning tree loop detection logic, adding new
connections may take 30 to 60 seconds for the affected interfaces
and/or LAN to become operational.
Features of the Cisco Small Business
4
Smart Switch
This section describes the exterior of the advanced smart switches
including ports, LEDs, and connections.
Front Panel Ports
The ports and LEDs are located on the front panel of the switch.
RJ-45 Ethernet Ports—Use these ports to connect network devices, such
as computers, printers, and access points, to the switch.
8
200E Series Advanced Smart Switches