Cisco 2960G-8TC - Catalyst Switch 시작하기 매뉴얼 - 페이지 16

{카테고리_이름} Cisco 2960G-8TC - Catalyst Switch에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2960G-8TC - Catalyst Switch 23 페이지. 8-port switches

Connect to the Dual-Purpose Ports

Follow these steps:

Insert either an RJ-45 connector to the

Step 1

10/100/1000 port, or install an SFP module

into the SFP module slot, and connect a cable

to the SFP module port.

Only one port can be active at a time. If both

ports are connected, the SFP module port has

priority. The priority setting is not

configurable.

Insert the other cable end into the other device.

Step 2

Verify Port Connectivity

After you connect to the switch port and another device, the port LED turns amber while the switch

establishes a link. This process takes about 30 seconds, and then the LED turns green when the switch

and the target device have an established link. If the LED is off, the target device might not be turned

on, there might be a cable problem, or there might be a problem with the adapter installed in the target

device. See the "In Case of Difficulty" section on page 16 for information about online assistance.

If you experience difficulty, help is available here and on Cisco.com. This section includes Express

Setup troubleshooting, how to reset the switch, how to access help online, and where to find more

information.

5 x

6 x

7 x

C a t a l y

8 x

s t 2 9 6

er ie s