Cisco 3020 - Cisco Catalyst Blade Switch 시작하기 매뉴얼 - 페이지 14

{카테고리_이름} Cisco 3020 - Cisco Catalyst Blade Switch에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3020 - Cisco Catalyst Blade Switch 37 페이지. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Cisco 3020 - Cisco Catalyst Blade Switch에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (31 페이지), 빠른 사양 (12 페이지), 릴리스 노트 (41 페이지), 릴리스 노트 (27 페이지), 릴리스 노트 (23 페이지), 릴리스 노트 (21 페이지), 설치 매뉴얼 (21 페이지)

페이지 인쇄

Cisco 3020 - Cisco Catalyst Blade Switch 시작하기 매뉴얼

Enter the IP address 10.0.0.1 and press Enter.

Step 9

The Express Setup home page appears.

Step 10 Go to "Completing the Express Setup Fields" section on page 17 to finish setting up the switch

module using the Express Setup screen of the Device Manager.

Using the Onboard Administrator to Assign an IP Address to the

Switch Module fa0 Interface

For the switch module to obtain an IP address for the fa0 interface through the Onboard

Administrator, these conditions must be met:

• The blade server is powered on and connected to the network.

• Basic configuration of the Onboard Administrator is completed, and you have the username and

password for the Onboard Administrator.

• A DHCP server is configured on the network segment to which the blade server is connected,

or the Onboard Administrator is configured to run as a DHCP server.

See the Onboard Administrator user guide at

Note

http://www.hp.com/go/bladesystem/documentation

and using the Onboard Administrator.

for more information about configuring