Cisco 5509 - Catalyst Chassis Switch 빠른 설치 매뉴얼 - 페이지 6
{카테고리_이름} Cisco 5509 - Catalyst Chassis Switch에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 5509 - Catalyst Chassis Switch 17 페이지. Wireless controller
Cisco 5509 - Catalyst Chassis Switch에 대해서도 마찬가지입니다: 설치 매뉴얼 (34 페이지)
페이지 인쇄
3
Connect the Switch to the Network (continued)
Connect the switch ports to the network
Note: If you are not sure which cable and connector to use for a particular module, refer to
the Catalyst 5000 Series Module Installation Guide.
RJ-45
To connect to modules with RJ-45 interfaces, use
Category 5 UTP (100BaseTX, 10/100BaseTX, CDDI,
Token Ring, ATM), Category 3 UTP (10BaseT), or Type 1
STP (Token Ring) cables with male RJ-45 interfaces.
6
Media-Independent Interface (MII)
Supervisor Engine I and II modules with 100BaseTX
uplinks have MII ports in addition to RJ-45 ports. To
connect to the MII interfaces, use Category 5 UTP
cables with male MII connectors.