Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 설치 참고 사항 - 페이지 3

{카테고리_이름} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 14 페이지. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대해서도 마찬가지입니다: 솔루션 매뉴얼 (17 페이지), 설치 참고 사항 (46 페이지), 백서 (19 페이지), 설명 (1 페이지), 제품 게시판 (6 페이지), 공지 사항 (4 페이지), 데이터시트 (9 페이지), 데이터시트 (18 페이지), 백서 (18 페이지), 구성 매뉴얼 (8 페이지), 설치 참고 사항 (28 페이지), 문제 해결 매뉴얼 (11 페이지), 설치 참고 사항 (18 페이지), 사용자 설명서 (17 페이지), 설치 참고 사항 (24 페이지), 매뉴얼 (19 페이지), 설치 참고 사항 (36 페이지)

페이지 인쇄
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 설치 참고 사항
Figure 1
WS-X6K-SUP1
SUPERVISOR I
Status LEDs
For information about using the PCMCIA Flash PC cards, see the
page

Preventing Electrostatic Discharge Damage

Follow these guidelines to prevent electrostatic discharge (ESD) damage:
•
•
•
•
Caution
For safety, periodically check the resistance value of the antistatic strap. The measurement should be
between 1 and 10 megohms.

Installing and Removing a Flash PC Card

Before you install a Flash PC card, verify that the card's write-protect switch is off. When the card is
oriented with the printing side up and the edge connector end away from you, the write-protect switch
is located on the front edge of the card, as shown in
Not all Flash PC cards have the write-protect switch.
Note
78-6507-06
Supervisor Engine Flash PC Card Slot
Switch load
CONSOLE port
display
Switch
Load
100%
CONSOLE
PORT
MODE
CONSOLE
1%
CONSOLE PORT MODE
switch
RESET button
6.
Always use an ESD wrist or ankle strap, and ensure that it makes good skin contact.
Connect the equipment end of the strap to the ESD connector on the switch.
Place a removed Flash PC card on an antistatic surface or in a static shielding bag. If the card will
be returned to the factory, immediately place it in a static shielding bag.
Avoid contact between the card and clothing. The wrist strap only protects the card from ESD
voltages on the body; ESD voltages on clothing can still cause damage.
PCMCIA LED
LINK LEDs
PORT 1
PCMCIA
EJECT
PCMCIA slot
1000BASE-X GBIC Uplink Ports
Figure
Catalyst 6500 Series Supervisor Engine Flash PC Card Installation Note
Preventing Electrostatic Discharge Damage
PORT 2
"Using Flash PC Cards" section on
2.
3