Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Catatan Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Catatan Instalasi untuk Beralih Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 14 halaman. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Juga untuk Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Panduan Solusi (17 halaman), Catatan Instalasi (46 halaman), Buku Putih (19 halaman), Deskripsi (1 halaman), Buletin Produk (6 halaman), Pemberitahuan (4 halaman), Lembar data (9 halaman), Lembar data (18 halaman), Buku Putih (18 halaman), Panduan Konfigurasi (8 halaman), Catatan Instalasi (28 halaman), Panduan Pemecahan Masalah (11 halaman), Catatan Instalasi (18 halaman), Panduan Pengguna (17 halaman), Catatan Instalasi (24 halaman), Manual (19 halaman), Catatan Instalasi (36 halaman)

Halaman Cetak
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Catatan Instalasi
Figure 1
WS-X6K-SUP1
SUPERVISOR I
Status LEDs
For information about using the PCMCIA Flash PC cards, see the
page

Preventing Electrostatic Discharge Damage

Follow these guidelines to prevent electrostatic discharge (ESD) damage:
•
•
•
•
Caution
For safety, periodically check the resistance value of the antistatic strap. The measurement should be
between 1 and 10 megohms.

Installing and Removing a Flash PC Card

Before you install a Flash PC card, verify that the card's write-protect switch is off. When the card is
oriented with the printing side up and the edge connector end away from you, the write-protect switch
is located on the front edge of the card, as shown in
Not all Flash PC cards have the write-protect switch.
Note
78-6507-06
Supervisor Engine Flash PC Card Slot
Switch load
CONSOLE port
display
Switch
Load
100%
CONSOLE
PORT
MODE
CONSOLE
1%
CONSOLE PORT MODE
switch
RESET button
6.
Always use an ESD wrist or ankle strap, and ensure that it makes good skin contact.
Connect the equipment end of the strap to the ESD connector on the switch.
Place a removed Flash PC card on an antistatic surface or in a static shielding bag. If the card will
be returned to the factory, immediately place it in a static shielding bag.
Avoid contact between the card and clothing. The wrist strap only protects the card from ESD
voltages on the body; ESD voltages on clothing can still cause damage.
PCMCIA LED
LINK LEDs
PORT 1
PCMCIA
EJECT
PCMCIA slot
1000BASE-X GBIC Uplink Ports
Figure
Catalyst 6500 Series Supervisor Engine Flash PC Card Installation Note
Preventing Electrostatic Discharge Damage
PORT 2
"Using Flash PC Cards" section on
2.
3