Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Catatan Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Catatan Instalasi untuk Beralih Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 14 halaman. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Juga untuk Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Panduan Solusi (17 halaman), Catatan Instalasi (46 halaman), Buku Putih (19 halaman), Deskripsi (1 halaman), Buletin Produk (6 halaman), Pemberitahuan (4 halaman), Lembar data (9 halaman), Lembar data (18 halaman), Buku Putih (18 halaman), Panduan Konfigurasi (8 halaman), Catatan Instalasi (28 halaman), Panduan Pemecahan Masalah (11 halaman), Catatan Instalasi (18 halaman), Panduan Pengguna (17 halaman), Catatan Instalasi (24 halaman), Manual (19 halaman), Catatan Instalasi (36 halaman)

Halaman Cetak
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Catatan Instalasi
Installing and Removing a Flash PC Card
Figure 2
Flash PC card
write protection
To install and remove a Flash PC card (see
You can insert and remove the Flash PC card with the power on.
Note
Connect an ESD-preventive strap to the ESD connector on the switch.
Step 1
Face the front panel of the switch, and hold the Flash PC card with the connector end toward the slot, as
Step 2
shown in
Insert the card into the slot until it completely seats in the connector at the back of the slot and the eject
Step 3
button pops out toward you, as shown in
Note
To eject a Flash PC card, press the ejector button until the card is free of the connector at the back of the
Step 4
slot, as shown in
Remove the card from the slot and place it in an antistatic bag.
Step 5
Catalyst 6500 Series Supervisor Engine Flash PC Card Installation Note
4
Locating the Flash PC Card Write Protection Switch
Flash PC card
Figure
3a.
The card does not insert all the way inside the slot; a portion of the card remains outside the slot.
Do not attempt to force the card past this point.
Figure
3c.
Flash PC card
shown with write
protection off
Figure
3), perform these steps:
Figure
3b.
78-6507-06