Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Catatan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Catatan Instalasi untuk Beralih Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 14 halaman. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Juga untuk Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Panduan Solusi (17 halaman), Catatan Instalasi (46 halaman), Buku Putih (19 halaman), Deskripsi (1 halaman), Buletin Produk (6 halaman), Pemberitahuan (4 halaman), Lembar data (9 halaman), Lembar data (18 halaman), Buku Putih (18 halaman), Panduan Konfigurasi (8 halaman), Catatan Instalasi (28 halaman), Panduan Pemecahan Masalah (11 halaman), Catatan Instalasi (18 halaman), Panduan Pengguna (17 halaman), Catatan Instalasi (24 halaman), Manual (19 halaman), Catatan Instalasi (36 halaman)

Contents

This installation note contains the following sections:

•

The supervisor engine Flash PC cards conform with the PCMCIA format. These models are available:

•

Note

The 16-MB MEM-C6K-FLC16M and 24-MB MEM-C6K-FLC24M linear Flash PC cards are formatted

for the Catalyst 6500 series supervisor engines and are ready to use.

The MEM-C6K-ATA-1-64M and 64-MB MEM-C6K-FLC64M Flash PC cards are not formatted. You

must format these cards (See

a description of the format command.) When you enter the dir disk0: or dir slot0: commands, an

unformatted Flash PC card returns a "bad device block info" or "invalid magic number" error message.

Note

Supervisor Engine 1 and Supervisor Engine 2 do not support the same Flash PC card format. To use a

Flash PC card with Supervisor Engine 2, you must format the card with Supervisor Engine 2. To use a

Flash PC card with Supervisor Engine 1, you must format the card with Supervisor Engine 1.

You can use Flash PC cards to store and boot software images, or they can be used as servers to store

software images for other systems. You can configure each supervisor engine with one Flash PC card in

slot 0.

Catalyst 6500 Series Supervisor Engine Flash PC Card Installation Note

16-MB MEM-C6K-FLC16M

24-MB MEM-C6K-FLC24M

64-MB MEM-C6K-FLC64M

MEM-C6K-ATA-1-64M

Table 1 on page 7 Commands for Using and Managing Flash DevicesTable

Figure 1

shows the front panel of a supervisor engine with the single PCMCIA slot, slot 0.

1for

78-6507-06