Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Kurulum Notu - Sayfa 2

Anahtar Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için çevrimiçi göz atın veya pdf Kurulum Notu indirin. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 14 sayfaları. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ayrıca Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için: Çözüm Kılavuzu (17 sayfalar), Kurulum Notu (46 sayfalar), Beyaz Kitap (19 sayfalar), Açıklama (1 sayfalar), Ürün Bülteni (6 sayfalar), Uyarı (4 sayfalar), Veri Sayfası (9 sayfalar), Veri Sayfası (18 sayfalar), Beyaz Kitap (18 sayfalar), Yapılandırma Kılavuzu (8 sayfalar), Kurulum Notu (28 sayfalar), Sorun Giderme Kılavuzu (11 sayfalar), Kurulum Notu (18 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kurulum Notu (24 sayfalar), Manuel (19 sayfalar), Kurulum Notu (36 sayfalar)

Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Kurulum Notu
Contents
Contents
This installation note contains the following sections:

Supervisor Engine Flash PC Cards

The supervisor engine Flash PC cards conform with the PCMCIA format. These models are available:
Note
The 16-MB MEM-C6K-FLC16M and 24-MB MEM-C6K-FLC24M linear Flash PC cards are formatted
for the Catalyst 6500 series supervisor engines and are ready to use.
The MEM-C6K-ATA-1-64M and 64-MB MEM-C6K-FLC64M Flash PC cards are not formatted. You
must format these cards (See
a description of the format command.) When you enter the dir disk0: or dir slot0: commands, an
unformatted Flash PC card returns a "bad device block info" or "invalid magic number" error message.
Note
Supervisor Engine 1 and Supervisor Engine 2 do not support the same Flash PC card format. To use a
Flash PC card with Supervisor Engine 2, you must format the card with Supervisor Engine 2. To use a
Flash PC card with Supervisor Engine 1, you must format the card with Supervisor Engine 1.
You can use Flash PC cards to store and boot software images, or they can be used as servers to store
software images for other systems. You can configure each supervisor engine with one Flash PC card in
slot 0.
Catalyst 6500 Series Supervisor Engine Flash PC Card Installation Note
2
16-MB MEM-C6K-FLC16M
24-MB MEM-C6K-FLC24M
64-MB MEM-C6K-FLC64M
MEM-C6K-ATA-1-64M
Table 1 on page 7 Commands for Using and Managing Flash DevicesTable
Figure 1
shows the front panel of a supervisor engine with the single PCMCIA slot, slot 0.
1for
78-6507-06