Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 설치 참고 사항 - 페이지 12

{카테고리_이름} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 46 페이지. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대해서도 마찬가지입니다: 설치 참고 사항 (14 페이지), 솔루션 매뉴얼 (17 페이지), 백서 (19 페이지), 설명 (1 페이지), 제품 게시판 (6 페이지), 공지 사항 (4 페이지), 데이터시트 (9 페이지), 데이터시트 (18 페이지), 백서 (18 페이지), 구성 매뉴얼 (8 페이지), 설치 참고 사항 (28 페이지), 문제 해결 매뉴얼 (11 페이지), 설치 참고 사항 (18 페이지), 사용자 설명서 (17 페이지), 설치 참고 사항 (24 페이지), 매뉴얼 (19 페이지), 설치 참고 사항 (36 페이지)

Removing a CFC or DFC Daughter Card

Removing the DFC3 Daughter Card from Modules without Stiffener Brackets

Warning

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly

touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94

To remove the DFC3 daughter card from modules that are not equipped with a stiffener bracket, follow

these steps:

Step 1

Attach an ESD grounding strap to your wrist and to ground.

If you are unsure about the correct way to attach an ESD grounding strap, refer to the

ESD Grounding Strap" section on page 42

Step 2

Remove the Ethernet module from the chassis.

If you are unsure about the correct procedure for removing a module from the switch chassis, refer to

the

Step 3

Place the Ethernet module on an antistatic mat with the front of the module facing toward you.

If your DFC daughter card has a small metal installation bracket as shown in

Step 4

Phillips-head screwdriver to remove the two cap nuts and the one screw securing the bracket. Set them

aside with the bracket. If there is no bracket, just remove the two cap nuts and the one screw.

Remove the remaining installation hardware. (See

Step 5

Note

The installation hardware shown in

installation hardware for a DFC3C or a DFC3CXL daughter card consists of 6 screws, 2 cap nuts, and 1

standoff.

Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note

"Removing an Ethernet Module from the Chassis" section on page 34

for instructions.

Figure

3.)

Figure 3

is for a DFC3B or DFC3BXL daughter card. The

"Attaching Your

for removal instructions.

Figure

3, use a No.1

78-15893-08