Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Nota de instalación - Página 12

Navegue en línea o descargue pdf Nota de instalación para Interruptor Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 46 páginas. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
También para Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Nota de instalación (14 páginas), Manual de soluciones (17 páginas), Libro Blanco (19 páginas), Descripción (1 páginas), Boletín de productos (6 páginas), Aviso (4 páginas), Ficha de datos (9 páginas), Ficha de datos (18 páginas), Libro Blanco (18 páginas), Manual de configuración (8 páginas), Nota de instalación (28 páginas), Manual de solución de problemas (11 páginas), Nota de instalación (18 páginas), Manual del usuario (17 páginas), Nota de instalación (24 páginas), Manual (19 páginas), Nota de instalación (36 páginas)

Removing a CFC or DFC Daughter Card

Removing the DFC3 Daughter Card from Modules without Stiffener Brackets

Warning

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly

touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94

To remove the DFC3 daughter card from modules that are not equipped with a stiffener bracket, follow

these steps:

Step 1

Attach an ESD grounding strap to your wrist and to ground.

If you are unsure about the correct way to attach an ESD grounding strap, refer to the

ESD Grounding Strap" section on page 42

Step 2

Remove the Ethernet module from the chassis.

If you are unsure about the correct procedure for removing a module from the switch chassis, refer to

the

Step 3

Place the Ethernet module on an antistatic mat with the front of the module facing toward you.

If your DFC daughter card has a small metal installation bracket as shown in

Step 4

Phillips-head screwdriver to remove the two cap nuts and the one screw securing the bracket. Set them

aside with the bracket. If there is no bracket, just remove the two cap nuts and the one screw.

Remove the remaining installation hardware. (See

Step 5

Note

The installation hardware shown in

installation hardware for a DFC3C or a DFC3CXL daughter card consists of 6 screws, 2 cap nuts, and 1

standoff.

Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note

"Removing an Ethernet Module from the Chassis" section on page 34

for instructions.

Figure

3.)

Figure 3

is for a DFC3B or DFC3BXL daughter card. The

"Attaching Your

for removal instructions.

Figure

3, use a No.1

78-15893-08