Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 설치 참고 사항 - 페이지 17

{카테고리_이름} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 46 페이지. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대해서도 마찬가지입니다: 설치 참고 사항 (14 페이지), 솔루션 매뉴얼 (17 페이지), 백서 (19 페이지), 설명 (1 페이지), 제품 게시판 (6 페이지), 공지 사항 (4 페이지), 데이터시트 (9 페이지), 데이터시트 (18 페이지), 백서 (18 페이지), 구성 매뉴얼 (8 페이지), 설치 참고 사항 (28 페이지), 문제 해결 매뉴얼 (11 페이지), 설치 참고 사항 (18 페이지), 사용자 설명서 (17 페이지), 설치 참고 사항 (24 페이지), 매뉴얼 (19 페이지), 설치 참고 사항 (36 페이지)

To remove a DFC3 daughter card from a WS-X6748-GE-TX Ethernet module that is equipped with a

stiffener bracket, follow these steps:

Attach an ESD grounding strap to your wrist and to ground.

Step 1

If you are unsure about the correct way to attach an ESD grounding strap, refer to the

ESD Grounding Strap" section on page 42

Remove the WS-X6748-GE-TX Ethernet module from the Catalyst 6500 series switch.

Step 2

If you are unsure about the correct procedure for removing a module from the switch chassis, refer to

the

"Removing and Installing Ethernet Modules in the Chassis" section on page 34

instructions.

Place the module on an antistatic mat or antistatic foam with the front of the module facing toward you.

Step 3

If your DFC daughter card has a small metal installation bracket as shown in

Step 4

Phillips-head screwdriver to remove the two cap nuts and the one screw securing the bracket. Set them

aside with the bracket. If there is no installation bracket, remove the two cap nuts and the one screw.

Step 5

Use a Phillips-head screwdriver to remove the remaining installation hardware. (See

Figure 7

Stiffener

bracket

78-15893-08

for instructions.

Removing the Installation Hardware (DFC3B/DFC3BXL Shown) (WS-X6748-GE-TX

Equipped with a Front Stiffener Bracket)

WS-X5530

Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note

Removing a CFC or DFC Daughter Card

Figure

Stiffener bracket tabs, DFC

daughter card mounted

underneath tabs.

"Attaching Your

for removal

7, use a No.1

Figure

7.)

Installation

bracket. May

or may not

be present