Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Kurulum Notu - Sayfa 17

Anahtar Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için çevrimiçi göz atın veya pdf Kurulum Notu indirin. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 46 sayfaları. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ayrıca Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için: Kurulum Notu (14 sayfalar), Çözüm Kılavuzu (17 sayfalar), Beyaz Kitap (19 sayfalar), Açıklama (1 sayfalar), Ürün Bülteni (6 sayfalar), Uyarı (4 sayfalar), Veri Sayfası (9 sayfalar), Veri Sayfası (18 sayfalar), Beyaz Kitap (18 sayfalar), Yapılandırma Kılavuzu (8 sayfalar), Kurulum Notu (28 sayfalar), Sorun Giderme Kılavuzu (11 sayfalar), Kurulum Notu (18 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kurulum Notu (24 sayfalar), Manuel (19 sayfalar), Kurulum Notu (36 sayfalar)

To remove a DFC3 daughter card from a WS-X6748-GE-TX Ethernet module that is equipped with a

stiffener bracket, follow these steps:

Attach an ESD grounding strap to your wrist and to ground.

Step 1

If you are unsure about the correct way to attach an ESD grounding strap, refer to the

ESD Grounding Strap" section on page 42

Remove the WS-X6748-GE-TX Ethernet module from the Catalyst 6500 series switch.

Step 2

If you are unsure about the correct procedure for removing a module from the switch chassis, refer to

the

"Removing and Installing Ethernet Modules in the Chassis" section on page 34

instructions.

Place the module on an antistatic mat or antistatic foam with the front of the module facing toward you.

Step 3

If your DFC daughter card has a small metal installation bracket as shown in

Step 4

Phillips-head screwdriver to remove the two cap nuts and the one screw securing the bracket. Set them

aside with the bracket. If there is no installation bracket, remove the two cap nuts and the one screw.

Step 5

Use a Phillips-head screwdriver to remove the remaining installation hardware. (See

Figure 7

Stiffener

bracket

78-15893-08

for instructions.

Removing the Installation Hardware (DFC3B/DFC3BXL Shown) (WS-X6748-GE-TX

Equipped with a Front Stiffener Bracket)

WS-X5530

Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note

Removing a CFC or DFC Daughter Card

Figure

Stiffener bracket tabs, DFC

daughter card mounted

underneath tabs.

"Attaching Your

for removal

7, use a No.1

Figure

7.)

Installation

bracket. May

or may not

be present