Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Kurulum Notu - Sayfa 18

Anahtar Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için çevrimiçi göz atın veya pdf Kurulum Notu indirin. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 46 sayfaları. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ayrıca Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için: Kurulum Notu (14 sayfalar), Çözüm Kılavuzu (17 sayfalar), Beyaz Kitap (19 sayfalar), Açıklama (1 sayfalar), Ürün Bülteni (6 sayfalar), Uyarı (4 sayfalar), Veri Sayfası (9 sayfalar), Veri Sayfası (18 sayfalar), Beyaz Kitap (18 sayfalar), Yapılandırma Kılavuzu (8 sayfalar), Kurulum Notu (28 sayfalar), Sorun Giderme Kılavuzu (11 sayfalar), Kurulum Notu (18 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kurulum Notu (24 sayfalar), Manuel (19 sayfalar), Kurulum Notu (36 sayfalar)

Removing a CFC or DFC Daughter Card

Note

Step 6

With your left hand, lift slightly at the location shown in

card up and down to unseat the daughter card from the module connectors.

Figure 8

Step 7

Holding the DFC3 daughter card with both hands, carefully lift the back end of the DFC3 daughter card

up slightly to clear the module connectors, and then carefully slide the DFC3 daughter card out from

under the two front stiffener bracket tabs. Lift the DFC3 daughter card straight up from the module (see

Figure

pad, or in an antistatic bag.

Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note

The two screws securing the DFC3 daughter card that pass through the front stiffener bracket

tabs are longer than the remaining DFC installation screws.

Unseating the DFC Connectors (WS-X6748-GE-TX Equipped with a Front Stiffener

Bracket)

WS-X5530

9) and immediately place the removed DFC3 daughter card on an antistatic mat, antistatic foam

Figure

Lift here

8, and gently rock the DFC3 daughter

Lift

here

78-15893-08