DigiPos DS-810 사용자 설명서 - 페이지 7

{카테고리_이름} DigiPos DS-810에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiPos DS-810 14 페이지.

5. Be sure to note the correct direction that the paper comes off the roll.

6. Pull out a small amount of paper, as shown. Then, close the cover.

7. Tear off the paper as shown.

2-4. Di p Switch Setting

The printer is set up at the factory to be appropriate for almost all users. On the other hand,

offers some more settings for users with special requirements.

It has DIP switches that allow you to change communication setting, such as handshaking and parity

check, as well as print density.

Your printer has one set of DIP switches. The functions of the switches are shown in the following

tables.

♣Note : Power off. And open the cover of Dip Switch and change setting.

2-4-1. Serial Interface Specification

DIP Switch Setting (Standard)

FUNCTION

Hexadecimal

Cut Mode

Handshaking

Paper Low Mode

Paper Low Detect

Print Density

Function

SW-3

Low Power

Normal

Dark

Baud rate selection

Transmission Speed

SW-9

115200 BPS

9600 BPS

19200 BPS

38400BPS

OFF

HEXDUMP

NORMAL

Full Cut

Partial Cut

XON/XOFF

DTR/DSR

Do not detect

SW-4

OFF

SW-10

OFF