DigiPos DS-810 Kullanıcı Kılavuzu - Sayfa 7
Yazıcı DigiPos DS-810 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DigiPos DS-810 14 sayfaları.
5. Be sure to note the correct direction that the paper comes off the roll.
6. Pull out a small amount of paper, as shown. Then, close the cover.
7. Tear off the paper as shown.
10
2-4. Di p Switch Setting
The printer is set up at the factory to be appropriate for almost all users. On the other hand,
offers some more settings for users with special requirements.
It has DIP switches that allow you to change communication setting, such as handshaking and parity
check, as well as print density.
Your printer has one set of DIP switches. The functions of the switches are shown in the following
tables.
♣Note : Power off. And open the cover of Dip Switch and change setting.
2-4-1. Serial Interface Specification
DIP Switch Setting (Standard)
SW
FUNCTION
2
Hexadecimal
5
Cut Mode
6
Handshaking
8
Paper Low Mode
Paper Low Detect
Print Density
Function
SW-3
Low Power
Normal
Normal
Dark
Baud rate selection
Transmission Speed
SW-9
115200 BPS
9600 BPS
19200 BPS
38400BPS
ON
OFF
HEXDUMP
NORMAL
Full Cut
Partial Cut
XON/XOFF
DTR/DSR
Do not detect
SW-4
ON
ON
OFF
ON
ON
OFF
OFF
OFF
SW-10
ON
ON
OFF
ON
ON
OFF
OFF
OFF
11