Cisco 9124 - mds multilayer fabric switch 하드웨어 설치 매뉴얼 - 페이지 15

{카테고리_이름} Cisco 9124 - mds multilayer fabric switch에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 9124 - mds multilayer fabric switch 36 페이지. Mds 9000 series
Cisco 9124 - mds multilayer fabric switch에 대해서도 마찬가지입니다: 사양 (2 페이지), 데이터시트 (9 페이지), 사양 (3 페이지), 구성 매뉴얼 (49 페이지), 릴리스 노트 (48 페이지), 릴리스 노트 (44 페이지), 릴리스 노트 (36 페이지), 릴리스 노트 (22 페이지), 릴리스 노트 (3 페이지), 릴리스 노트 (40 페이지), 매뉴얼 (16 페이지)

페이지 인쇄
Cisco 9124 - mds multilayer fabric switch 하드웨어 설치 매뉴얼
Chapter 2
Installing the Cisco MDS 9100 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Installing Cisco MDS 9100 Series Switch Rear-Facing into Cabinet
To install a Cisco MDS 9120 or 9140 Switch rear-facing into a cabinet using the rack-mount kit provided
with the switch (for cabinets with insufficient front-facing clearance), follow the steps in this section. If
you are installing a Cisco MDS 9134 Switch, Cisco MDS 9134 Switch, or a Cisco MDS 9124 Switch
rear-facing into a cabinet using the rack-mount kit provided, see
Cisco MDS 9134 Switch, or a Cisco MDS 9124 Switch Rear-Facing into Cabinet" section on page
Install the slider rails in the rack:
Step 1
a.
b.
c.
Figure 2-10
OL-21514-01
Position one of the slider rails against the front rack-mounting rails and align the screw holes as
shown in
Figure
2-10. Then attach them using two 12-24 screws or two 10-32 screws, depending on
the rack rail thread type. For racks with square holes, first install the 12-24 cage nuts.
Repeat with the other slider rail on the other front side of the rack.
Use the tape measure and level to verify that the rails are horizontal and at the same height.
Installing the Slider Rails to the Front Rack-Mounting Rails
Rear cabinet
mounting
rails
Installing the Switch in a Cabinet with Insufficient Front Clearance
"Installing a Cisco MDS 9148 Switch,
Front cabinet
mounting
rails
Cisco MDS 9100 Series Hardware Installation Guide
2-17.
2-15