Cisco 9124 - mds multilayer fabric switch 하드웨어 설치 매뉴얼 - 페이지 13

{카테고리_이름} Cisco 9124 - mds multilayer fabric switch에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 9124 - mds multilayer fabric switch 36 페이지. Mds 9000 series
Cisco 9124 - mds multilayer fabric switch에 대해서도 마찬가지입니다: 사양 (2 페이지), 데이터시트 (9 페이지), 사양 (3 페이지), 구성 매뉴얼 (49 페이지), 릴리스 노트 (48 페이지), 릴리스 노트 (44 페이지), 릴리스 노트 (36 페이지), 릴리스 노트 (22 페이지), 릴리스 노트 (3 페이지), 릴리스 노트 (40 페이지), 매뉴얼 (16 페이지)

페이지 인쇄
Cisco 9124 - mds multilayer fabric switch 하드웨어 설치 매뉴얼
Chapter 2
Installing the Cisco MDS 9100 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Installing Front Rack-Mount Brackets for Cabinets with 26 Inches or
Greater of Rail Spacings
The front rack-mount brackets for the Cisco MDS 9100 Series switch must be installed onto the switch
prior to installing the switch into the cabinet. Follow these steps for cabinets with front-mounting rail to
rear-mounting rail spacings greater or equal to 26 inches.
Install the front rack-mount brackets as follows:
Step 1
a.
b.
Install the C brackets as follows:
Step 2
Note
a.
b.
Figure 2-8
1
OL-21514-01
Position one of the front rack-mount brackets against the side of the switch and align the screw holes
as shown in
Figure
2-8. Then attach the bracket to the switch with the three M4 screws originally
provided with the bracket.
Repeat with the other front-rack mount bracket on the other side of the switch.
Two C brackets are shipped preinstalled on the switch, using three M3 screws per bracket. This
installation step is only necessary if the C brackets were removed.
Position one of the C brackets against the side of the switch and align the screw holes as shown in
Figure
2-8. Then attach the bracket to the switch with the three M3 screws originally provided with
the bracket.
Repeat with the other C bracket on the other side of the switch.
Front Rack-Mount Brackets and C Brackets Installed on the Cisco MDS 9100 Series
Front rack-mount bracket
Installing the Switch in a Cabinet with Insufficient Front Clearance
1
2
C bracket
Cisco MDS 9100 Series Hardware Installation Guide
2
2-13