Cisco 9124 - mds multilayer fabric switch Manuel d'installation du matériel - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} Cisco 9124 - mds multilayer fabric switch. Cisco 9124 - mds multilayer fabric switch 36 pages. Mds 9000 series
Également pour Cisco 9124 - mds multilayer fabric switch : Spécifications (2 pages), Fiche technique (9 pages), Spécifications (3 pages), Manuel de configuration (49 pages), Note de mise à jour (48 pages), Note de mise à jour (44 pages), Note de mise à jour (36 pages), Note de mise à jour (22 pages), Note de mise à jour (3 pages), Note de mise à jour (40 pages), Manuel (16 pages)

Imprimer la page
Cisco 9124 - mds multilayer fabric switch Manuel d'installation du matériel
Chapter 2
Installing the Cisco MDS 9100 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Installing Front Rack-Mount Brackets for Cabinets with 26 Inches or
Greater of Rail Spacings
The front rack-mount brackets for the Cisco MDS 9100 Series switch must be installed onto the switch
prior to installing the switch into the cabinet. Follow these steps for cabinets with front-mounting rail to
rear-mounting rail spacings greater or equal to 26 inches.
Install the front rack-mount brackets as follows:
Step 1
a.
b.
Install the C brackets as follows:
Step 2
Note
a.
b.
Figure 2-8
1
OL-21514-01
Position one of the front rack-mount brackets against the side of the switch and align the screw holes
as shown in
Figure
2-8. Then attach the bracket to the switch with the three M4 screws originally
provided with the bracket.
Repeat with the other front-rack mount bracket on the other side of the switch.
Two C brackets are shipped preinstalled on the switch, using three M3 screws per bracket. This
installation step is only necessary if the C brackets were removed.
Position one of the C brackets against the side of the switch and align the screw holes as shown in
Figure
2-8. Then attach the bracket to the switch with the three M3 screws originally provided with
the bracket.
Repeat with the other C bracket on the other side of the switch.
Front Rack-Mount Brackets and C Brackets Installed on the Cisco MDS 9100 Series
Front rack-mount bracket
Installing the Switch in a Cabinet with Insufficient Front Clearance
1
2
C bracket
Cisco MDS 9100 Series Hardware Installation Guide
2
2-13