Cisco 9124 - mds multilayer fabric switch Instrukcja instalacji sprzętu - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja instalacji sprzętu dla Przełącznik Cisco 9124 - mds multilayer fabric switch. Cisco 9124 - mds multilayer fabric switch 36 stron. Mds 9000 series
Również dla Cisco 9124 - mds multilayer fabric switch: Specyfikacje (2 strony), Arkusz danych (9 strony), Specyfikacje (3 strony), Podręcznik konfiguracji (49 strony), Uwaga dotycząca wydania (48 strony), Uwaga dotycząca wydania (44 strony), Uwaga dotycząca wydania (36 strony), Uwaga dotycząca wydania (22 strony), Uwaga dotycząca wydania (3 strony), Uwaga dotycząca wydania (40 strony), Podręcznik (16 strony)

Drukuj stronę
Cisco 9124 - mds multilayer fabric switch Instrukcja instalacji sprzętu
Chapter 2
Installing the Cisco MDS 9100 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Installing Front Rack-Mount Brackets for Cabinets with 26 Inches or
Greater of Rail Spacings
The front rack-mount brackets for the Cisco MDS 9100 Series switch must be installed onto the switch
prior to installing the switch into the cabinet. Follow these steps for cabinets with front-mounting rail to
rear-mounting rail spacings greater or equal to 26 inches.
Install the front rack-mount brackets as follows:
Step 1
a.
b.
Install the C brackets as follows:
Step 2
Note
a.
b.
Figure 2-8
1
OL-21514-01
Position one of the front rack-mount brackets against the side of the switch and align the screw holes
as shown in
Figure
2-8. Then attach the bracket to the switch with the three M4 screws originally
provided with the bracket.
Repeat with the other front-rack mount bracket on the other side of the switch.
Two C brackets are shipped preinstalled on the switch, using three M3 screws per bracket. This
installation step is only necessary if the C brackets were removed.
Position one of the C brackets against the side of the switch and align the screw holes as shown in
Figure
2-8. Then attach the bracket to the switch with the three M3 screws originally provided with
the bracket.
Repeat with the other C bracket on the other side of the switch.
Front Rack-Mount Brackets and C Brackets Installed on the Cisco MDS 9100 Series
Front rack-mount bracket
Installing the Switch in a Cabinet with Insufficient Front Clearance
1
2
C bracket
Cisco MDS 9100 Series Hardware Installation Guide
2
2-13