Cisco 9124 - mds multilayer fabric switch 하드웨어 설치 매뉴얼 - 페이지 19

{카테고리_이름} Cisco 9124 - mds multilayer fabric switch에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 9124 - mds multilayer fabric switch 36 페이지. Mds 9000 series
Cisco 9124 - mds multilayer fabric switch에 대해서도 마찬가지입니다: 사양 (2 페이지), 데이터시트 (9 페이지), 사양 (3 페이지), 구성 매뉴얼 (49 페이지), 릴리스 노트 (48 페이지), 릴리스 노트 (44 페이지), 릴리스 노트 (36 페이지), 릴리스 노트 (22 페이지), 릴리스 노트 (3 페이지), 릴리스 노트 (40 페이지), 매뉴얼 (16 페이지)

페이지 인쇄
Cisco 9124 - mds multilayer fabric switch 하드웨어 설치 매뉴얼
Chapter 2
Installing the Cisco MDS 9100 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Insert the switch into the rack:
Step 2
Using both hands, position the switch with the back of the switch between the rear rack-mounting
a.
rails as shown in
Figure 2-14
Align the two C brackets on either side of the switch with the slider rails installed in the rack. Slide
b.
the C brackets onto the slider rails and then gently slide the switch all the way into the rack. If the
switch does not slide easily, try realigning the C brackets on the slider rails.
Connect the power cord that you previously routed through the open cutout of the slider rail to the
Step 3
switch, as shown in
the rail opening.
Note
OL-21514-01
Figure
2-14.
Sliding a Cisco MDS 9134, Cisco MDS 9134 Switch, or the Cisco MDS 9124 Switch
(Rear-Facing) on the Notched Slider Rails
Front cabinet
mounting
rails
Figure
2-15. Limit the length of the power cord between the back of the chassis and
If you failed to route the power cord through the open cutout of the slider rail as directed in Step
1, remove the switch and rails and remount the rails using the correct method. Do not connect
the power cord by routing it over the top of the slider rail, as shown in
installation is hazardous.
Installing the Switch in a Cabinet with Insufficient Front Clearance
Rear cabinet
mounting
rails
Cisco MDS 9100 Series Hardware Installation Guide
Figure
2-16. This type of
2-19