Cisco 9124 - mds multilayer fabric switch Hardware installatiehandleiding - Pagina 19

Blader online of download pdf Hardware installatiehandleiding voor {categorie_naam} Cisco 9124 - mds multilayer fabric switch. Cisco 9124 - mds multilayer fabric switch 36 pagina's. Mds 9000 series
Ook voor Cisco 9124 - mds multilayer fabric switch: Specificaties (2 pagina's), Gegevensblad (9 pagina's), Specificaties (3 pagina's), Configuratiehandleiding (49 pagina's), Release Release (48 pagina's), Release Release (44 pagina's), Release Release (36 pagina's), Release Release (22 pagina's), Release Release (3 pagina's), Release Release (40 pagina's), Handmatig (16 pagina's)

Chapter 2

Installing the Cisco MDS 9100 Series

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Insert the switch into the rack:

Step 2

Using both hands, position the switch with the back of the switch between the rear rack-mounting

rails as shown in

Figure 2-14

Align the two C brackets on either side of the switch with the slider rails installed in the rack. Slide

the C brackets onto the slider rails and then gently slide the switch all the way into the rack. If the

switch does not slide easily, try realigning the C brackets on the slider rails.

Connect the power cord that you previously routed through the open cutout of the slider rail to the

Step 3

switch, as shown in

the rail opening.

Note

OL-21514-01

Figure

2-14.

Sliding a Cisco MDS 9134, Cisco MDS 9134 Switch, or the Cisco MDS 9124 Switch

(Rear-Facing) on the Notched Slider Rails

Front cabinet

mounting

rails

Figure

2-15. Limit the length of the power cord between the back of the chassis and

If you failed to route the power cord through the open cutout of the slider rail as directed in Step

1, remove the switch and rails and remount the rails using the correct method. Do not connect

the power cord by routing it over the top of the slider rail, as shown in

installation is hazardous.

Installing the Switch in a Cabinet with Insufficient Front Clearance

Rear cabinet

mounting

rails

Cisco MDS 9100 Series Hardware Installation Guide

Figure

2-16. This type of

2-19