Cisco ASR 900 Series 구성 매뉴얼 - 페이지 7

{카테고리_이름} Cisco ASR 900 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 900 Series 19 페이지. Configuring 1g traffic on 8-port 10 gigabit ethernet interface module
Cisco ASR 900 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (13 페이지), 구성 매뉴얼 (6 페이지), 구성 매뉴얼 (6 페이지)

페이지 인쇄

Command or Action

Example:

Device> enable

Step 2

configure terminal

Example:

Device# configure terminal

Step 3

cdp run

Example:

Device(config)# cdp run

Step 4

end

Example:

Device(config)# end

Disabling and Enabling Cisco Discovery Protocol on a Supported Interface

Disabling Cisco Discovery Protocol on a Supported Interface

If the encapsulation of an interface is changed, Cisco Discovery Protocol is reenabled on that interface even if Cisco Discovery

Protocol was previously disabled. For example, when interface encapsulation changes from PPP to High-Level Data Link Control

(HDLC), Cisco Discovery Protocol is reenabled on that interface even though it was explicitly disabled with the no cdp run command

on that interface. This behavior is by design. The encapsulation changes the Layer 2 protocol configured for that interface and resets

the interface configuration to the default Cisco Discovery Protocol state of being enabled, assuming that Cisco Discovery Protocol

is enabled globally on the device.

Procedure

Command or Action

Step 1

enable

Example:

Device> enable

Purpose

• Enter your password if prompted.

Enters global configuration mode.

Enables Cisco Discovery Protocol on a supported device.

Exits configuration mode and returns to privileged EXEC

mode.

Purpose

Enables privileged EXEC mode.

• Enter your password if prompted.