Cisco ASR 920 series 설치 매뉴얼 - 페이지 24

{카테고리_이름} Cisco ASR 920 series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 920 series 42 페이지. Aggregation services router
Cisco ASR 920 series에 대해서도 마찬가지입니다: 설치 매뉴얼 (36 페이지), 시작하기 (6 페이지), 하드웨어 설치 매뉴얼 (46 페이지), 매뉴얼 (36 페이지)

페이지 인쇄

1. Connect to the 10/100/1000 Ports

Connect to SFP Modules

• Let the ports autonegotiate both speed and duplex.

• Set the port speed and duplex parameters on both ends of the connection.

SUMMARY STEPS

1. When connecting to workstations, servers, and routers, connect a straight-through cable to an RJ-45

connector on the front panel.When connecting to routers or repeaters, use a crossover cable.

2. Connect the other end of the cable to an RJ-45 connector on the other device. The port LED turns on when

both the router and the connected device have established link.

3. Reconfigure and reboot the connected device, if necessary.

4. Repeat Steps 1 through 3 to connect each device.

DETAILED STEPS

Step 1

When connecting to workstations, servers, and routers, connect a straight-through cable to an RJ-45 connector on the

front panel.When connecting to routers or repeaters, use a crossover cable.

Note

You can use the mdix auto interface configuration command in the CLI to enable the automatic

medium-dependent interface crossover (auto-MDIX) feature. When the auto-MDIX feature is enabled, the router

detects the required cable type for copper Ethernet connections and configures the interfaces accordingly.

Therefore, you can use either a crossover or a straight-through cable for connections to a copper 10/100/1000,

or an SFP module port on the router, regardless of the type of device on the other end of the connection.

Step 2

Connect the other end of the cable to an RJ-45 connector on the other device. The port LED turns on when both the

router and the connected device have established link.

If the port LED does not turn on, the device at the other end might not be turned on, or there might be a cable problem

or a problem with the adapter installed in the attached device.

On user network interface (UNI) ports, the port LED is green after the link is established.

Note

Step 3

Reconfigure and reboot the connected device, if necessary.

Step 4

Repeat Steps 1 through 3 to connect each device.

Connect to SFP Modules

This section describes how to connect to SFP modules. For instructions on how to connect to fiber-optic SFP

modules, see the Connecting to Fiber-Optic SFP Modules, page 3-20 .

For instructions about how to install or remove an SFP module, see the Installing and Removing SFP Modules,

page 3-16 .

Connect to Fiber-Optic SFP Modules

Follow these steps to connect a fiber-optic cable to an SFP module:

Class 1 laser product. Statement 1008

Warning

Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide

Installing the Cisco ASR 920 Series Router