Cisco ASR 920 series 매뉴얼 - 페이지 19

{카테고리_이름} Cisco ASR 920 series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 920 series 36 페이지. Aggregation services router
Cisco ASR 920 series에 대해서도 마찬가지입니다: 설치 매뉴얼 (36 페이지), 시작하기 (6 페이지), 설치 매뉴얼 (42 페이지), 하드웨어 설치 매뉴얼 (46 페이지)

페이지 인쇄

Installing the Cisco ASR 920 Series Router

6. Place the removed SFP module in an antistatic bag or other protective environment.

DETAILED STEPS

Step 1

Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.

Step 2

Disconnect the cable from the SFP module, and insert a dust plug into the cable end.

For reattachment, note which cable connector plug is send (TX) and which is receive (RX).

Tip

Step 3

Unlock and remove the SFP module, as shown in the following figure.

If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp latch is obstructed

and you cannot use your index finger to open it, use a small, flat-blade screwdriver or other long, narrow instrument to

open the bale-clasp latch.

Figure 19: Removing a Bale-Clasp Latch SFP Module

Step 4

Grasp the SFP module between your thumb and index finger, and carefully remove it from the module slot.

Step 5

For fiber-optic SFP modules, insert a dust plug into the optical ports of the SFP module to keep the optical interfaces

clean.

Step 6

Place the removed SFP module in an antistatic bag or other protective environment.

Installing the Cisco ASR 920 Series Router

Remove SFP Modules