Cisco Catalyst 2960 Series 시작하기 매뉴얼 - 페이지 13

{카테고리_이름} Cisco Catalyst 2960 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 2960 Series 25 페이지. Compact switches
Cisco Catalyst 2960 Series에 대해서도 마찬가지입니다: 데이터시트 (16 페이지), 데이터시트 (11 페이지), 데이터시트 (9 페이지), 제품 게시판 (3 페이지), 제품 게시판 (5 페이지), 데이터시트 (21 페이지), 사양 (2 페이지), 브로셔 및 사양 (10 페이지), 데이터시트 (15 페이지), 데이터시트 (28 페이지), 브로셔 (17 페이지), 설치 매뉴얼 (27 페이지)

페이지 인쇄
Cisco Catalyst 2960 Series 시작하기 매뉴얼
Chapter 1
Getting Started Guide

Equipment That You Supply

Before You Begin

OL-9368-03
You need to supply a number-2 Phillips screwdriver to rack-mount the switch.
When determining where to install the switch, verify that these guidelines are met:
Airflow around the switch and
•
through the vents is unrestricted.
Temperature around the switch
•
does not exceed 113°F (45°C).
•
Humidity around the switch does
not exceed 85 percent.
Clearance to the switch front and
•
rear panels meets these conditions:
–
Front-panel LEDs can be
easily read.
Access to ports is sufficient for
–
unrestricted cabling.
AC power cord can reach from
–
the AC power outlet to the
connector on the switch rear
panel.
Cabling is away from sources of
•
electrical noise, such as radios,
power lines, and fluorescent
lighting fixtures.
Altitude at the installation site is
•
not greater than 10,000 feet
(3,049 meters).
For 10/100 and 10/100/1000 ports,
•
the cable length from a switch to
an attached device cannot exceed
328 feet (100 meters).
For cable lengths for small
•
form-factor pluggable (SFP)
modules, see the documentation
that shipped with the module.
Catalyst 2960 Switch Getting Started Guide
Rack-Mounting
1-11