Cisco Catalyst 2960 Series Başlangıç Kılavuzu - Sayfa 13

Anahtar Cisco Catalyst 2960 Series için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco Catalyst 2960 Series 25 sayfaları. Compact switches
Ayrıca Cisco Catalyst 2960 Series için: Veri Sayfası (16 sayfalar), Veri Sayfası (11 sayfalar), Veri Sayfası (9 sayfalar), Ürün Bülteni (3 sayfalar), Ürün Bülteni (5 sayfalar), Veri Sayfası (21 sayfalar), Teknik Özellikler (2 sayfalar), Broşür ve Teknik Özellikler (10 sayfalar), Veri Sayfası (15 sayfalar), Veri Sayfası (28 sayfalar), Broşür (17 sayfalar), Kurulum Kılavuzu (27 sayfalar)

Sayfayı Yazdır
Cisco Catalyst 2960 Series Başlangıç Kılavuzu
Chapter 1
Getting Started Guide

Equipment That You Supply

Before You Begin

OL-9368-03
You need to supply a number-2 Phillips screwdriver to rack-mount the switch.
When determining where to install the switch, verify that these guidelines are met:
Airflow around the switch and
•
through the vents is unrestricted.
Temperature around the switch
•
does not exceed 113°F (45°C).
•
Humidity around the switch does
not exceed 85 percent.
Clearance to the switch front and
•
rear panels meets these conditions:
–
Front-panel LEDs can be
easily read.
Access to ports is sufficient for
–
unrestricted cabling.
AC power cord can reach from
–
the AC power outlet to the
connector on the switch rear
panel.
Cabling is away from sources of
•
electrical noise, such as radios,
power lines, and fluorescent
lighting fixtures.
Altitude at the installation site is
•
not greater than 10,000 feet
(3,049 meters).
For 10/100 and 10/100/1000 ports,
•
the cable length from a switch to
an attached device cannot exceed
328 feet (100 meters).
For cable lengths for small
•
form-factor pluggable (SFP)
modules, see the documentation
that shipped with the module.
Catalyst 2960 Switch Getting Started Guide
Rack-Mounting
1-11