Digiscan Labs iPROTECT 1216 매뉴얼 - 페이지 10

{카테고리_이름} Digiscan Labs iPROTECT 1216에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digiscan Labs iPROTECT 1216 13 페이지. Counter surveillance 3-band rf detector

Locating/pinpointing the bug

If a suspicious place with a high RF level is found, choose the ONE BAND display mode by pressing

the joystick

approached to the transmitter the RF level will increase. Increase the threshold periodically to narrow

the area of search when in ALARM mode. The HISTOGRAM will help you not to omit the intermittent

signals by displaying the recent measurements obtained during the last 5 seconds.

After finding the precise place start its physical inspection.

Do not forget to return the ALL BANDS display mode when continuing the general search.

If a bugging device is found, do not stop. There may be others!

Signature

By analyzing the signal's audio footprint and some other properties the iProtect 1216 is able to identify

and display certain protocols on the status display:

GSM

DECT Active / Idle

Message

GSM

DECT Idle

DECT Active

BT_WF

The identification is made when the signal is strong or when the source is approached closely.

The signature helps the user to distinguish between a real danger and interference in some cases,

particularly when it is impossible to reach the transmitter physically.

Detection distance

The detection distance of any RF detector (near-field receiver) depends on two major factors:

and select the dangerous band with the help of the

BT_WF

Transmitter's output power

Presence of interference

Protocol

GSM

DECT in the idle state

DECT in the active state

Wi-Fi, Bluetooth and other wireless

devices in the 2.4 Ghz band

buttons. As the detector is