Cisco Catalyst 2960-CX 매뉴얼 - 페이지 15
{카테고리_이름} Cisco Catalyst 2960-CX에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 2960-CX 24 페이지.
Cisco Catalyst 2960-CX에 대해서도 마찬가지입니다: 제품 개요 (15 페이지)
페이지 인쇄
- 1. Table of Contents
- 2. Finding Feature Information
- 3. Prerequisites for Switch Stacks
- 4. Restrictions for Switch Stacks
- 5. Information about Switch Stacks
- 6. How to Configure a Switch Stack
- 7. Troubleshooting the Switch Stack
- 8. Monitoring the Device Stack
- 9. Configuration Examples for Switch Stacks
- 10. Additional References for Switch Stacks
Managing Switch Stacks
Step 3
Step 4
Step 5
Step 6
Step 7
Setting the Stack Member Priority Value
This optional task is available only from the stack master.
Follow these steps to assign a priority value to a stack member:
Procedure
Step 1
Step 2
Command or Action
switch current-stack-member-number
renumber new-stack-member-number
Example:
Switch(config)# switch 3 renumber 4
end
Example:
Switch(config)# end
reload slot stack-member-number
Example:
Switch# reload slot 4
show switch
Example:
showSwitch
copy running-config startup-config
Example:
Switch# copy running-config
startup-config
Command or Action
enable
Example:
Switch enable
switch stack-member-number priority
new-priority-number
Example:
Setting the Stack Member Priority Value
Purpose
Specifies the current stack member number and
the new stack member number for the stack
member. The range is 1 to 8.
You can display the current stack member
number by using the show switch user EXEC
command.
Returns to privileged EXEC mode.
Resets the stack member.
Verify the stack member number.
(Optional) Saves your entries in the
configuration file.
Purpose
Enables privileged EXEC mode. Enter your
password if prompted.
Specifies the stack member number and the new
priority for the stack member. The stack
member number range is 1 to 8. The priority
value range is 1 to 15.
Managing Switch Stacks
15