Cisco Catalyst 2960-S Series 시작 설명서 - 페이지 14

{카테고리_이름} Cisco Catalyst 2960-S Series에 대한 시작 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 2960-S Series 31 페이지. Switch getting
Cisco Catalyst 2960-S Series에 대해서도 마찬가지입니다: 데이터시트 (28 페이지), 설치 매뉴얼 (27 페이지)

페이지 인쇄

Other Management Options

Planning and Creating Switch Stacks

Note

Catalyst 2960-S Switch Getting Started Guide

You can use SNMP management applications such as CiscoWorks LAN

Management Solution (LMS) and Cisco netManager to configure and manage the

switch. You also can manage it from an SNMP-compatible workstation that is

running platforms such as Cisco netManager or SunNet Manager.

The Cisco Configuration Engine is a network management device that works with

embedded Cisco Networking Services (CNS) agents in the switch software. You

can use it to automate initial configurations and configuration updates on the

switch.

See the

"Accessing Help Online" section on page 28

documentation.

This section applies only to the Catalyst 2960-S stacking switches.

Before connecting the switches in a stack, keep in mind these switch stack

guidelines:

Connect only Catalyst 2960-S switches in a switch stack.

•

Install the FlexStack module and the FlexStack cable for stacking capability.

You can order them in a kit from your Cisco sales representative:

C2960S-STACK=.

Consider the length of

•

you might need different sized cables.

sales representative:

CAB-STK-E-0.5M= (0.5-meter cable)

–

CAB-STK-E-1M= (1-meter cable)

–

CAB-STK-E-3M= (3-meter cable)

–

For additional stacking guidelines, see the switch hardware installation guide on

Cisco.com. For concepts and procedures to manage switch stacks, see the switch

software configuration guide on Cisco.com.

Catalyst 2960-S Switch Getting Started Guide

FlexStack cable. Depending on your configurations,

You can order them from your Cisco

for a list of supporting

OL-19793-02