Cisco Catalyst 2960-X 하드웨어 설치 매뉴얼 - 페이지 22
{카테고리_이름} Cisco Catalyst 2960-X에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 2960-X 34 페이지.
Cisco Catalyst 2960-X에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (25 페이지), 하드웨어 매뉴얼 (20 페이지)
페이지 인쇄
Connecting FlexStack-Extended modules (Optional)
Procedure
Step 1
Remove the dust covers from the FlexStack cables, and store them for future use.
Step 2
Insert one end of the FlexStack cable into the stack port of the first switch. Insert the other end of the cable
into the stack port on the other switch. Make sure that you insert the cables in completely until you feel them
snap into place.
Note
Step 3
Replace the dust covers when you remove the FlexStack cables from the connectors.
Caution
Connecting FlexStack-Extended modules (Optional)
Always use a Cisco-approved FlexStack cable to connect the switches.
This is only supported on the stack-capable switches.
Note
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
22
When you connect the FlexStack cable to the STACK 1 port, the tab should be above the connector.
When you connect the FlexStack cable to the STACK 2 port, the tab should be below the connector.
Removing and installing the FlexStack cable can shorten its useful life. Do not remove and insert
the cable more often than is absolutely necessary.
Switch Installation
OL-28309-02