FIBARO FGBHDW-002 운영 매뉴얼 - 페이지 5

{카테고리_이름} FIBARO FGBHDW-002에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FIBARO FGBHDW-002 7 페이지. Door / window sensor contact & temperature sensor
FIBARO FGBHDW-002에 대해서도 마찬가지입니다: 운영 매뉴얼 (13 페이지), 빠른 시작 매뉴얼 (9 페이지)

페이지 인쇄

#6: Functionalities

Opening/closing detection:

NOTE

the Door/window Sensor detects opening/closing using Hall effect

use app that allows to

sensor and reports it to your ioS device.

configure parameters

to change the default

opening is detected by separating the sensor's body and the magnet.

state of sensor and its

Changing the state is indicated with one blink.

indications.

Tamper detection:

the Door/window Sensor detects tampering whenever the accesso-

ry is detached from the surface or casing is opened and reports it to

your ioS device. tampering is indicated with two blinks.

Temperature measuring:

the Door/window Sensor measures ambient temperature every 10

minutes. if the measured temperature differs from previously reported

by at least 1°C (1.8°F), accessory reports it to your ioS device.

Battery level measuring:

the Door/window Sensor measures battery level every 24 hours and

reports it to your ioS device. additionally, if battery level is below 15%,

the accessory will report low level battery status to your ioS device.

FunCtionaLitieS

#7: Configurable parameters

1. Opening/closing detection – LED indication

this parameter allows choose if opening/closing is indicated by the

built-in LeD diode.

available settings: 0 – indications disabled

1 – indications enabled

Default setting:

1 (indications enabled)

2. Door/window state

this parameter allows to set in what state is door/window when the

magnet is close to the sensor.

available settings: 0 – closed when magnet near

1 – opened when magnet near

Default setting:

0 (closed when magnet near)

ConFiGuRaBLe PaRameteRS