Cisco Catalyst 3110G 시작하기 매뉴얼 - 페이지 13

{카테고리_이름} Cisco Catalyst 3110G에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 3110G 31 페이지. Catalyst switch module for ibm bladecenter
Cisco Catalyst 3110G에 대해서도 마찬가지입니다: 보충 설명서 (20 페이지), 하드웨어 설치 매뉴얼 (48 페이지)

페이지 인쇄
Cisco Catalyst 3110G 시작하기 매뉴얼
From the I/O Module Tasks menu, click Configuration.
Step 5
In the I/O Module Configuration section, click the bay number that corresponds to the
Step 6
location of the I/O module (switch module) that you are configuring. The applicable bay
number appears in the window, followed by other related I/O-module information, including
the IP address. The I/O-module information is divided into two sections: Current IP
Configuration and New Static IP Configuration (Figure 7).
Figure 7
AMM I/O Module Configuration Window
In the New Static IP Configuration section, enter the new IP address, the subnet mask, and
Step 7
the gateway address. Click Save.
The IP address for the I/O module must be on the same subnet as the management module.
The management module does not check for invalid IP addresses.
13