Cisco Catalyst 3110G Getting Started Manual - Page 13
Browse online or download pdf Getting Started Manual for Switch Cisco Catalyst 3110G. Cisco Catalyst 3110G 31 pages. Catalyst switch module for ibm bladecenter
Also for Cisco Catalyst 3110G: Supplementary Manual (20 pages), Hardware Installation Manual (48 pages)
Print Page
From the I/O Module Tasks menu, click Configuration.
Step 5
In the I/O Module Configuration section, click the bay number that corresponds to the
Step 6
location of the I/O module (switch module) that you are configuring. The applicable bay
number appears in the window, followed by other related I/O-module information, including
the IP address. The I/O-module information is divided into two sections: Current IP
Configuration and New Static IP Configuration (Figure 7).
Figure 7
AMM I/O Module Configuration Window
In the New Static IP Configuration section, enter the new IP address, the subnet mask, and
Step 7
the gateway address. Click Save.
The IP address for the I/O module must be on the same subnet as the management module.
The management module does not check for invalid IP addresses.
13