FIBARO FGMS-001 운영 매뉴얼 - 페이지 8

{카테고리_이름} FIBARO FGMS-001에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FIBARO FGMS-001 20 페이지. Motion sensor
FIBARO FGMS-001에 대해서도 마찬가지입니다: 운영 매뉴얼 (2 페이지), 운영 매뉴얼 (11 페이지)

페이지 인쇄

NOTE

Resetting the device is

not the recommend-

ed way of removing

the device from the

Z-Wave network. Use

reset procedure only if

the primary controller

is missing or inopera-

ble. Certain device re-

moval can be achieved

by the procedure of

removing described in

"Adding/removing the

device" on page 6.

NOTE

Command Class Basic

value is related to the

status of motion sensor

(0x00 - no motion, 0xFF

- motion detected).

OPERATInG ThE DEvICE

Seismograph mode:

The Motion Sensor can be configured to work as a simple earthquake

detector, by setting the parameter 24 value to 1. Reports with scale of

the vibrations (in the Modified Mercalli Scale) will be sent immediate-

ly after vibrations have been detected. Minimal power of vibrations

that will be reported, can be set in parametr 20. Once the vibrations

cease and time of sustaining alarm elapses, reports will be stopped.

Orientation in space:

The Motion Sensor has a built-in accelerometer. When the parameter 24

is set to 2, Z-Wave network controller will be informed on the Sensor's

orientation in space by sending report after triggering tamper alarm.

Resetting the Motion Sensor:

Reset procedure erases the memory, including all information on the

Z-Wave network and the main controller.

1. Open the cover.

2. Press and hold the B-button.

3. Wait for visual indicator to glow yellow (2nd menu position).

4. Release the B-button.

5. Click the B-button to confirm selection.

6. After few seconds the device will be reset, which is signalled with

the red, fading visual indicator colour.

Notification report:

The device uses notification Command Class to report different events.

notification Type

home Security

Event

Tampering, product covering removed

Motion Detection, unknown location