Cisco Catalyst 3550 시작하기 매뉴얼 - 페이지 18

{카테고리_이름} Cisco Catalyst 3550에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 3550 33 페이지. Cisco catalyst 3550: supplementary guide
Cisco Catalyst 3550에 대해서도 마찬가지입니다: 제품 게시판 (3 페이지), 제품 게시판 (5 페이지), 데이터시트 (21 페이지)

페이지 인쇄

Slide the exposed area of the 6-gauge wire

Step 3

into the ground lug, and use the crimping

tool to crimp the lug to the wire.

Using the ratcheting screwdriver, torque the ground lug screws to 15 lbf-in. (240

Step 4

ounce-force inches [ozf-in.]) to attach the ground lug to the switch.

Wiring the DC Input Power Source

Follow these steps:

On the terminal block connector, identify the positive and negative feed positions.

Step 1

Step 2

Strip each of the four wires coming from the

DC power source to 0.27 inch (6.6 mm)

± 0.02 inch (0.5 mm). Do not strip more

than the recommended amount of wire.

Insert the four exposed wires from the DC-input power source into the terminal block plug,

Step 3

matching positive to positive and negative to negative for both the A and the B feed wires.

0.27 inch (6.6 mm)