Digisol DG-GR6010 빠른 설치 매뉴얼 - 페이지 13

{카테고리_이름} Digisol DG-GR6010에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digisol DG-GR6010 17 페이지. Xpon onu router with 1 pon and 1 giga port
Digisol DG-GR6010에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (20 페이지)

페이지 인쇄
Digisol DG-GR6010 빠른 설치 매뉴얼

Troubleshooting

1. After power on, all the LEDs are lit?

Reasons:
1) Power connection errors.
2) Power is not normal.
Solution:
1) Check that the power cable is connected.
2) The rear panel of the power supply is turned on.

2. LINK / ACT LED does not turn on?

Reasons:
1) Network cable is damaged or loose connection.
2) Cable type error.
3) Long lines outside the allowable range.
Solution:
1) Replace the network cable, and pay attention to the standard
Ethernet cable must be parallel or crossing lines.

3. After some time device stop working?

Reasons:
1) Power supply is not working properly.
2) The equipment from overheating.
Solution:
1) Check if there is contact with abnormal voltage is too high or too low.
2) Check the ambient conditions, vents are normal ventilation.
4. REG LED flashes?
Reasons:
1) Fiber failure.
2) Central office equipment failure.
Solution:
1) Inspect fiber is connected properly, is connected to the correct
connector, optical power is normal.
2) Contact your operator.