FIBARO FGMS-001 운영 매뉴얼 - 페이지 7

{카테고리_이름} FIBARO FGMS-001에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FIBARO FGMS-001 20 페이지. Motion sensor
FIBARO FGMS-001에 대해서도 마찬가지입니다: 운영 매뉴얼 (2 페이지), 운영 매뉴얼 (11 페이지)

페이지 인쇄

#5: Operating the device

Controlling the Motion Sensor using the B-button:

The Motion Sensor is equipped with a B-button, which allows to use

the menu and additionally perform the following actions:

1x click: wake up the device or select the desired menu option (if

menu is active)

3x click: add/remove the device to/from a Z-Wave network

Holding: enter/navigate through the menu

Visual indications:

The Motion Sensor is equipped with a LED diode, signalling sensor's

operating modes and alarms. In addition the visual indicator may in-

form of the Z-Wave network range and the current temperature.

visual indicator signalling modes:

1. Motion Alarm colour will vary depending on the temperature. The

colour and the signalling mode can be set in parameter 80.

2. Tamper alarm is signalled with an alternating blinking in LAPD

colours (red - blue - white).

3. The Z-Wave node Info command frame is signalled with glowing in

blue. node Info command frame is sent each time the device wakes up.

4. Menu position is signalled with assigned illumination colour.

Menu:

Menu allows to perform Z-Wave network actions. In order to use menu:

1. Press and hold the B-button.

2. Wait for the device to indicate desired position with a colour:

•

VIOLET - Z-Wave network's range test

•

YELLOW - device reset

3. Release the B-button.

4. Click the B-button to confirm selection.

Waking up the Motion Sensor:

The Motion Sensor needs to be woken up to receive information on new

configurations from the controller, like parameters and associations.

To wake up the sensor manually triple click the B-button located in-

side the housing.

Controlling the Motion Sensor with FIBARO Home Center controller:

The Motion Sensor has a bulit-in motion detector, temperature sensor

and light intensity sensor, which make it a multi-channel device. In the

home Center interface it will be presented as three devices.

OPERATInG ThE DEvICE