Sharp Carousel R-1500 요리 매뉴얼 - 페이지 10

{카테고리_이름} Sharp Carousel R-1500에 대한 요리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Carousel R-1500 40 페이지. Over the range models
Sharp Carousel R-1500에 대해서도 마찬가지입니다: 요리 매뉴얼 (40 페이지), 서비스 매뉴얼 (44 페이지)

페이지 인쇄

U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S

8 VENTILATION SYSTEM (PREPARING OVEN FOR

INSTALLATION)

This Microwave Oven/Hood is designed for adaptation to three types of hood ventilation systems. Select the type

required for your installation.

Recirculating — non-vented, ductless. Follow installation procedure (A). Recirculating requires the use of the

Charcoal Filter, which has already been installed in the oven.

Horizontal Exhaust — outside ventilation. Follow installation procedure (B).

Vertical Exhaust — outside ventilation. Follow installation procedure (C).

(A) RECIRCULATING: NON-VENTED, DUCTLESS

OPERATION

The unit is shipped assembled for recirculating.

1. The Exhaust Damper Assembly 9 is not required for recirculating operation.

NOTE:

2. The Charcoal Filter should be replaced every 6 to 12 months, depending on use.

3. The Charcoal Filter RK-240 is also sold as an accessory. See Page 14 for ordering information.

(B) HORIZONTAL EXHAUST: OUTSIDE VENTILATION

1. Remove 2 screws from back edge and 3 screws from the top center of Fan Cover Bracket. Save 2 screws to be

used later and discard remaining 3. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow

on the Fan Cover Bracket, as shown in Figure 7.

2. Lift Hood Fan Unit carefully and slip wires out of cavity. See Figure 8. CAUTION: Do not pull or stretch hood fan

wiring.

3. Rotate the Hood Fan Unit 180˚ so that the fan blade openings are facing the back of the oven. See Figure 9 (A).

Replace Hood Fan Unit into the oven. Be careful not to pinch the wire and the Hood Fan Unit. See Figure 9 (B).

4. Put the wire back into the cavity. See Figure 10.

Figure 7

Figure 9

Downloaded from

www.Manualslib.com

(A) Rotate 180˚

(B)

manuals search engine

Figure 8

Figure 10

Save fan cover bracket for

future instructions.