Sharp AQUOS LC-26P55E 운영 매뉴얼 - 페이지 16
{카테고리_이름} Sharp AQUOS LC-26P55E에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AQUOS LC-26P55E 28 페이지. Aquos lcd colour television
페이지 인쇄
Menu operations
Power Control menu
MENU
[ Power Control ]
Audio
No Signal Off
No Operation Off
No Signal Off
Menu Operation: A (page 11)
When set to "Enable", the power will automatically shut
down if no signal inputs for 15 minutes.
• Five minutes before the power shuts down, remaining time
displays every minute.
NOTE
• When a TV programme finishes, this function may not
operate.
No Operation Off
Menu Operation: A (page 11)
When set to "Enable", the power will automatically shut
down if there is no operation for 3 hours.
• Five minutes before the power shuts down, remaining time
displays every minute.
Power Management
Menu Operation: A (page 11)
When set, the power will automatically shut down.
Item
Off:
• No power management
• Factory preset value.
Mode1: • If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the PC and the signal
inputs again, the TV stays off.
• The TV turns on again by pressing a on the
TV or B on the remote control unit. (See page
7.)
Mode2: • If no signal inputs for 8 seconds, the power
shuts down.
• When you start using the PC and the signal
inputs again, the TV turns on.
• The TV turns on again by pressing a on the
TV or B on the remote control unit. (See page
7.)
Setup menu
MENU
[ Setup ]
Setup
Auto Installation
Programme Setup
Child Lock
Position
WSS
4:3 Mode
[Panorama]
Rotate
[Normal]
Language
[English]
14
Power Control
[Disable]
[Disable]
TV/AV only
TV/AV only
PC only
Option
[On]
Auto Installation
You can run Auto Installation again, even after setting
up the preset channels.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Auto Installation", and then
press OK.
If you have already set the PIN under "Child Lock",
enter it here.
• See page 16 for setting PIN.
4
Press c/d to select "Yes", and then press OK.
5
You can set language and country the same as in
the initial auto installation. Follow steps 1 and 2
on page 7.
Programme Setup
This section describes how to set up analogue TV
channels manually.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Programme Setup", and
then press OK.
If you have already set the PIN under "Child Lock",
enter it here.
• See page 16 for setting PIN.
4
Press a/b to select "Auto Search", "Manual
Adjust", "Sort" or "Erase Programme", and then
press OK.
Auto Search
Manual Adjust
Sort
Erase Programme
Auto Search
You can automatically search for and download TV
channels by performing the procedure below. This is
the same function as from programme auto search to
preset download in Auto Installation.
1
Repeat steps 1 to 4 in Programme Setup.
2
Press c/d to select "Yes", and then press OK.
1 Programme auto search
2 Auto labelling
3 Auto sorting
4 Preset download
TV only
TV only
No
Yes