AccuTemp STEAM'N'HOLD 설치 및 운영자 매뉴얼 - 페이지 8
{카테고리_이름} AccuTemp STEAM'N'HOLD에 대한 설치 및 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AccuTemp STEAM'N'HOLD 15 페이지. Vacoom steamer
페이지 인쇄INSTALLATION-CONT.
ELECTRICAL SUPPLY
The AccuTemp STEAM'N'HOLD™ appliance has
been designed, manufactured and tested to meet
or exceed the Underwriters Laboratories safety
standards. To ensure safety is maintained in your
installation,
it is important that the following paragraphs are
understood before attempting to apply power to
your STEAM'N'HOLD™. If there is any doubt as to
whether your supply receptacle is of the correct
voltage, amperage, or is properly grounded,
consult a qualified electrician or authorized
service agent.
POWER REQUIREMENTS
AC power requirements are listed on the data
plate located on the left side access panel of
the appliance. This appliance should never
be connected to a circuit operating at more
than 150 VAC to ground and should always be
connected to an individual branch circuit. Make
sure the voltage at the supply receptacle is within
±10% of the voltage listed on the appliance data
plate. Connection to any other voltage may
permanently damage your STEAM'N'HOLD™ or
cause premature
component failure. Damage of this type is not
covered under the product warranty. Each
appliance comes equipped with a connected
6 foot power cord and
power requirements of each appliance.
Damage caused by removal or modification of
factory standard plug is not covered by product
warranty.
GROUNDING
To reduce the risk of serious shock or death
in the event of an electrical short circuit,
this appliance must be grounded. The
STEAM'N'HOLD™ is equipped with a cord
having a grounding wire and plug, which must
MP4011-2207
plug, rated for the
STEAM'N'HOLD™
DRAIN
These models do not include a drain
connection and a full size steam table pan or a
1/1 gastronome pan with a minimum depth of
4 inches is required.
The 4"drain pan, part number SH-DP can
be ordered as an accessory . Optionally a
2 1/2"drain pan with an elbow for a drain
connection, part number AT1A-3155 is
available.
HOOD VENTILATION
Some local building codes require the this
appliance to be under an exhaust hood. Please
check local building code requirements before
completing installation of this appliance.
8